WebApr 25, 2014 · First run ifconfig to get the interface name: # ifconfig Now run ethtool to get the driver name (or however you want to get the driver name). Lets imagine its eth0. # ethtool -i eth0 In this case lets pretend the driver name DRIVERNAME. Now check that the driver is not a kernel built-in driver with modprobe. # modprobe -D DRIVERNAME Web12. RX errors mean that your NIC is receiving malformed frames from the transmitting switchport. Frame errors mean CRC failures on receipt of a frame. The root cause of this could be a bad cable, or a bad interface on either the machine or the switch. Try replacing the cable, then moving to another port on the switch. Share.
使用Linux ethtool命令对LAN 78xx系列EEPROM进行编程
Web$ ifconfig eth0 down $ modprobe -r e1000 $ modprobe e1000 $ ifconfig eth0 up Use ethtool to find out your NIC module: $ ethtool -i eth0 In front of driver you see your … WebMar 29, 2006 · Let us say you want this to 1400 then you can use any one of the following command to setup MTU: # ifconfig eth0 mtu 1400. OR. # ip link set dev eth0 mtu 1400. Verify that new mtu is setup with following command: $ ip link list. OR. $ /sbin/ifconfig. To make the setting permanent for eth0, edit the configuration file: business shared calendar app
Finding original MAC address from hardware itself
WebI don't think you're really looking for link speed, this is the dedicated connection speed of your connection. If you have ethtool installed (in repos) you can use this command to … WebThe ethtool statistics should be favoured over those of ifconfig. The dropped counter in ifconfig was originally intended to log protocol-only drops, such as a protocol handler … WebDec 10, 2010 · Re: NICS in ethtool and ifconfig - What is 'eth#' I suspect that ethtool will work with just about any interface name that points at a real interface (well at least a LAN one). That said, the bit about "all linux NICs use the naming pattern or eth#" is something one cannot really count on. business share agreement